Brand New from Circuit Specialists Europe
Introducing the CSI 5505S regulated DC bench power supply.
A highly reliable, variable DC Bench Power Supply with built in short circuit and thermal protection.
This is a linear unit, not a switch mode supply
The power
supply unit is equipped with protection circuits that protect the units
from short circuits and over temperature by shutting down for safety.
It features independent serial and parallel mode operation.
This power
supply is suitable for the laboratory, electronics, communications
equipment maintenance, production line, scientific research and
educational institutions.
This bench power supply functions in series or parallel modes for great flexibility.
The CSI 5505S bench power supply technical specifications:
Independent mode: TWO independent 0-30V outputs
Series mode: Output from 0-60V & 0-5A
Parallel mode: Output from 0-10A & 0-30V
Also provides a 5V fixed output @ 3A
Load regulation: <0.1%+3mV (rating current <3A)
<0.2% +3mA
Ripple and noise: <1mVrms 5Hz-1MHz
<3mArms
Voltage accuracy: +/-0.5%rdg+2byte
Current accuracy: +/-.5%rdg+2byte
Display resolution: +/-0.5%rdg+2byte
Rated output: 5.0V +/-0.1V 3A
Series specifications:
Load regulation: less than 50mV
Ripple and noise: (5Hz~1MHz) <=3mVRMS
Parallel characteristics:
Load regulation: less than 50mV
Ripple and noise: (5Hz-1MHz) CV less than
1mV<=6A), CV less than
1.5mV (I>6A)
Dimensions: (L)360mm x (D)260mm x (H)160mm
CC Mode: How it Works
In
CC mode the user may set the CURRENT LIMIT as desired up to the full limit of the unit. The current is set as follows:
To
set this variable current limit, connect a short (test lead or wire
jumper) directly across the Power supply output terminals. The CC light
should illuminate. Then adjust the current limit value up or down using
the current adjust dial.
When the meter displays the desired current limit value, remove the
short from the power supply and the unit will now be set as desired.
If you remove Power from the unit (or turn it OFF) you must reset any
current limit value you previously had set. It will default to the maximum current value.
This product was added to our catalog on Tuesday 20 December, 2011.
